Sawdust Smart
Menu

Build idea

Walnut and maple key fobs

I made this Share a photo of your version.

two walnut and one maple key fob with rounded corners, each with a drilled hole and steel split ring, on linen concept — not a real build.

Small walnut and maple key fobs with rounded corners and one drilled hole for a steel split ring, a quick stocking stuffer made from offcuts. Drill all the holes along one long strip first, then crosscut the fobs to the same length against a stop block, so every hole sits the same distance from the end. Run the grain the long way so the end with the hole stays strong, then ease the edges and wipe on oil.

Rough size
About 3 x 1 x 3/8 in
Wood
Walnut or maple offcuts, grain running the long way

Tools you might use

  • Miter saw or handsaw with a stop block
  • Drill press or cordless drill
  • Brad-point drill bit
  • Combination square and awl
  • Clamps
  • Sanding block with 150- and 220-grit paper
  • Wipe-on oil or clear finish
  • Steel split key rings

Our tool picks for this idea: Clamps · Drill presses · Miter saws · Cordless drills · Measuring and marking tools

Key techniques

All build ideas